Our precision cut-off wheels are optimized for high precision cutting of different materials. They are as thin as possible in relation to the diameter to remove an absolute minimum of material, a critical factor when cutting expensive materials. Thin cut-off wheels limit the thermal damage and mechanical deformation during cutting. This again reduces the following grinding and polishing time.
Aka-Cut 1000 HV, based on Al2O3, is the optimal choice when cutting ferrous metals with a hardness of 500-1000 HV.
Aka-Cut 700 HV, based on Al2O3, is optimized for cutting ferrous metals with a hardness of 150-700 HV.
Aka-Cut 400 HV, based on SiC, is the best choice when high precision cutting of non-ferrous metals with a hardness of 50-400 HV is required.
Showing all 3 results
Precision Ferrous Metal Cutting
Aka-Cut 1000 HV, 150 mm
Precision Ferrous Metal Cutting
Aka-Cut 700 HV, 150 mm
Precision Non-Ferrous Metal Cutting
Aka-Cut 400 HV, 150 mm
FAQ
SiC cut-off wheels are typically used for cutting of non-ferrous metals and Al2O3 wheels for ferrous metals.
Al2O3 has a more blocky, round grain structure than SiC. It will wear slowly and give a long lifetime to the cut-off wheels, making it the correct choice for ferrous metals.
SiC is a rather brittle abrasive. When breaking down it creates new, sharp edges that are ideal for removing soft and ductile material.
Precision cut-off wheels are very thin, about 0.5 mm for a diameter of 150 mm. This will remove a minimum of material which is very important when cutting precious materials. The thinner the cut-off wheel the less energy is needed for cutting and this again reduces the possible heat damage and deformation in the sample, another advantage of precision cutting. However, these precision cut-off wheels also require a specific precision cut-off machine and cannot be used on larger laboratory type machines.
Our precision cutting wheel has a diameter of 150 mm. Below is a table converting the diameter from millimeters (mm) to inches (in) for your convenience. The value in inches is rounded to the nearest whole number to match standard inch sizes.
Diameter (mm)
Diameter (in)
150 mm
6 in
For precise measurements, please refer to the specifications in millimeters.
Contact us today for more
information or inquiries
If you’d like to discuss a project or collaboration, or have questions regarding our
products we’d love to hear from you. You can get in touch with the right person via the contact form or write to us at info@akasel.com.
We will get back to you as soon as possible. The typical response time is 2 work days.
Information regarding website language
We have detected that you are viewing this website from *C_CTRY*.
If this is correct, and you would like to visit our website for *C_CTRY*, please click the link below.
Note: Our Danish webshop is on the English website.