Titanium behaves differently than other non-ferrous materials during cutting. Titanium and its alloys tend to smear and clog up the cutting abrasives in the cut-off wheel. This causes burning and smearing on the sample surface and severe deformation. Aka-Cut Ti20 is using sharp SiC abrasives in a strong, but open bond to give space for removed debris thus reducing these problems. When choosing our titanium cut-off wheel Aka-Cut Ti20, you obtain a plane sample surface with minimal mechanical deformation and thermal damage. This cut-off wheel is optimized for cutting titanium and titanium alloys with a hardness of approximately 20 HRC or in the range of 100-350 HV. Different diameters are available for all our abrasive cut-off wheels.
Showing the single result
Titanium Cut-off Wheel
Aka-Cut Ti20
FAQ
Titanium cut-off wheels, sometimes also referred to as titanium saw blades, are typically based on SiC as abrasive.
Since titanium and titanium alloys are non-ferrous, the abrasive typically used is SiC. Aka-Cut Ti20 is based on SiC for optimal cutting results.
SiC is a rather brittle abrasive. When breaking down it creates new, sharp edges that are ideal for removing soft and ductile material. Therefore, cutting – or sawing – titanium with an Aka-Cut Ti20 gives the best cutting result with minimal mechanical deformation and thermal damage.
Titanium has a very high strength-to-density ratio but it is also very ductile, making it a challenge to cut. It is easily deformed and very often large burrs can be observed after improper cutting. Like other non-ferrous metals it is best cutting with SiC cut-off wheels, but both the binder and the abrasive size has to be modified to suit titanium in the best possible way. Our Aka-Cut Ti20 has the correct composition for cutting titanium.
Contact us today for more
information or inquiries
If you’d like to discuss a project or collaboration, or have questions regarding our
products we’d love to hear from you. You can get in touch with the right person via the contact form or write to us at info@akasel.com.
We will get back to you as soon as possible. The typical response time is 2 work days.
Information regarding website language
We have detected that you are viewing this website from *C_CTRY*.
If this is correct, and you would like to visit our website for *C_CTRY*, please click the link below.
Note: Our Danish webshop is on the English website.
En (US) 
En (UK)
De
zh-CN
Se
